i do not have stk500
i am using a breadboard
i am using atmega32
my first program was the demo FlashLeds
can u mention
the fuse bit settings needed
the frequency of operation
internal or external oscilator
Pls help
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
No prob. If i remember correctly the the atmega32 can be used in the default settings (from factory). In that case it uses an internal oscillator at 1MHz. The OS changes this to 8MHz at startup. Please try to flash the pre-compiled binaries first. When they do not run something is wrong with the chip or fuses.
If other difficulties occur, please post them here in as much detail as reasonably possible.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
i do not have stk500
i am using a breadboard
i am using atmega32
my first program was the demo FlashLeds
can u mention
the fuse bit settings needed
the frequency of operation
internal or external oscilator
Pls help
No prob. If i remember correctly the the atmega32 can be used in the default settings (from factory). In that case it uses an internal oscillator at 1MHz. The OS changes this to 8MHz at startup. Please try to flash the pre-compiled binaries first. When they do not run something is wrong with the chip or fuses.
If other difficulties occur, please post them here in as much detail as reasonably possible.