I use v.1.7.0 for Fsx, arma3 and Xplane10. When I updated to version 1.7.2 roll started to behave weirdly. I use 3point clip.
In 1.7.0 when I roll my head there is no pitch response and a little yaw, which is good.
In 1.7.2 rolling head to maybe 25 degrees results in 40 degrees of yaw and a lot of pitch. Translation changes a bit too.
In both version I'm using same profile, same model and model position. Fiddling with filters and reverses dosen't fix it.
I also notices same bug in opentrack but I cant reproduce it at the moment.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi!
I use v.1.7.0 for Fsx, arma3 and Xplane10. When I updated to version 1.7.2 roll started to behave weirdly. I use 3point clip.
In 1.7.0 when I roll my head there is no pitch response and a little yaw, which is good.
In 1.7.2 rolling head to maybe 25 degrees results in 40 degrees of yaw and a lot of pitch. Translation changes a bit too.
In both version I'm using same profile, same model and model position. Fiddling with filters and reverses dosen't fix it.
I also notices same bug in opentrack but I cant reproduce it at the moment.
Hmm... Help? Please?
I don't think that there were any changes between 1.7.0 and 1.7.2 that could cause this behavior.
Lacking further information, test cases, probable causes, I'm unable to help you.
It woulda helped if you submitted a video clip reproducing the issue, along with your model dimensions and center position.