|
From: Krzysztof L. <krz...@li...> - 2005-06-17 06:59:48
|
Timothy Legge wrote: > Hi > > If you are not subscribed to the etherboot-users list please do so. I > always get the messages to the list but sometimes my inbox gets full or > worse (your email was marked as spam for instance) OK. I am sending my reply here. > I don't have time tonight to look, but some additional details regarding > the hardware that you have would help. The issue you reference below > was only seen on one model of HP Vectra. Exactly. It is HP Vectra VL5/200 MMX. According to BIOS, the following devices are on: Parallel port - IRQ 7 Serial port 1 - IRQ 4 Serial port 2 - IRQ 3 IDE Adapters - IRQ 14 and 15 Integrated ethernet interface (PCNet/Fast) - ? USB interface - ? Modem - IRQ 3 or IRQ 4 (there is no modem, so I guess it does not matter) According to power-on setting, there should also be assigned IRQ 12 to PS/2 mouse. All PCI IRQ lines in BIOS are set to "Auto". Etherboot ROM is loaded using RPL (remote boot protocol). It prints the following settings: RPL-ROM-ADR: 0060 B0C1 3893 RPL-ROM-DMA: 5 RPL-ROM-IRQ: 2 RPL-ROM-PIO: FCE0 I have also tried creating Netboot boot rom with NDIS driver (from AMD site) and it does not work. I cannot create rom with packet driver, it says something about executable using too much memory. Hope this helps. Regards Krzysztof Lichota |
