i'm getting the following simulator error trying to install VMS 8.3, never encountered before.
I used always es40 under windows, but now I compiled it under UBUNTU 8.04 with gcc 4.2
ide0.1 aborting on command 0x00
ide0.1 aborting on command 0x00
ide0.1 aborting on command 0x00
ide0.1 aborting on command 0xec
Exception in CPU thread: System exception: cannot signal semaphore: count would exceed maximum.
Emulator Failure: Threading error: CPU thread has died: AlphaCPU.cpp, line 522
The above error happens after the Open VMS banner is printed out on the console.
I'm using a full IDE configuration and no vga_console. With only SCSI config and vga_console enabled I didn't get this fault, but the installation aborted after a while with a VMS error.
Did you get this fault before?
Thanks,
Fausto
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello all,
i'm getting the following simulator error trying to install VMS 8.3, never encountered before.
I used always es40 under windows, but now I compiled it under UBUNTU 8.04 with gcc 4.2
ide0.1 aborting on command 0x00
ide0.1 aborting on command 0x00
ide0.1 aborting on command 0x00
ide0.1 aborting on command 0xec
Exception in CPU thread: System exception: cannot signal semaphore: count would exceed maximum.
Emulator Failure: Threading error: CPU thread has died: AlphaCPU.cpp, line 522
The above error happens after the Open VMS banner is printed out on the console.
I'm using a full IDE configuration and no vga_console. With only SCSI config and vga_console enabled I didn't get this fault, but the installation aborted after a while with a VMS error.
Did you get this fault before?
Thanks,
Fausto