https://sourceforge.net/p/eqtrack/wiki/Basic-Features/Recent changes to Basic-FeaturesenMon, 21 May 2012 09:16:00 -0000https://sourceforge.net/p/eqtrack/wiki/Basic-Features/<pre>--- v3 +++ v4 @@ -32,4 +32,4 @@ * a beep at startup to confirm a correct start, * during parameter setting, when the value is at the (low or high) end of the range. -[Back](Basic) +[Back](../Basic) </pre>Jean-Etienne LAMIAUDMon, 21 May 2012 09:16:00 -0000https://sourceforge.netb1fe1f3fc8f04c9c6077a3b3511163ff2a93f29bhttps://sourceforge.net/p/eqtrack/wiki/Basic-Features/<pre>--- v2 +++ v3 @@ -31,3 +31,5 @@ * The buzzer also emits : * a beep at startup to confirm a correct start, * during parameter setting, when the value is at the (low or high) end of the range. + +[Back](Basic) </pre>Jean-Etienne LAMIAUDMon, 21 May 2012 09:07:59 -0000https://sourceforge.netb5ade0b852f00babe4b6dac8fcad0b6e6b045b50https://sourceforge.net/p/eqtrack/wiki/Basic-Features/<pre></pre>Jean-Etienne LAMIAUDMon, 05 Mar 2012 17:08:01 -0000https://sourceforge.net41fb09ec521d51d001709f88c3fab900e294ac0bhttps://sourceforge.net/p/eqtrack/wiki/Basic%253AFeatures/The main features of EQTrack Basic are : * Rotation of the equatorial motor at 3 selectable rates : * Tracking (ie: diurnal rotation compensation), itself selectable among 4 rates : * Sidereal, * Solar, * Lunar, * User defined. * Guide (plus or minus 20% on the tracking rate). * Slew (up to 2000 steps / sec) * Rotation of the declination motor at 2 selectable rates * Guide, * Slew. * The following rates are adjustable : * Sidereal tracking, * Solar tracking, * Lunar tracking, * User defined tracking, * Equatorial slew, * Declination guide, * Declination slew. * The power applied to the motors (hence the motor torque, and the consumption) is also adjustable for the same rates. * The rotation sense of the equatorial motor is also adjustable, to accommodate for a trip to the other hemisphere. * Any new setting is stored in EEPROM after 1 minute. * Power supply monitoring : * A LED is blinking at 1 second interval, * green when the power supply is high, * amber when the power supply starts getting low, * red when the power supply is low. * A buzzer alerts when the power supply degrades. * The buzzer also emits : * a beep at startup to confirm a correct start, * during parameter setting, when the value is at the (low or high) end of the range.Jean-Etienne LAMIAUDMon, 05 Mar 2012 16:53:45 -0000https://sourceforge.netb9b45648a26a60dd25397feedfdfd802722cd3a5