#8 Bug with using Load Alignment Point from Preset on UNPARK

[Denis Demyanov]

Hello!

I`m using EQASCOM 1.27q + MaxIM DL 5.24 + EQ6
I have a bug with automatically loading alignment points after reconnection to EQASCOM:
1. Unpark mount via EQASCOM
2. Target in MaxIm to same star and slewing to it.
3. Making image by camera -> pinpointing it-> Slewing error half of degree -> sync.
4. In Alignment List +1 point
5. Saving list with same name->enabling checkbutton Load Alignment Point from Preset on UNPARK
6. Parking mount
7. Disconnecting in Maxim
8. Turning off mount; turning on mount
9. Connecting mount via Maxim
10. Unpark mount via EQASCOM->in Alignment List 1 point was loaded from saved preset
11. Target in Maxim to that star and slewing to it.
12. Making image by camera -> pinpointing it-> Slewing error half of degree misalignment!

If after p.6 (Parking mount) I did not disconnect EQASCOM, unpark and slewing to that star, mount slewing correct without any error. I tried to repeat this user-case in different mount and different computer - the similar error.

Denis Demyanov.