Re: [Emc-users] Abort messes up position

[Jeff E. <je...@un...>]

On Fri, Mar 30, 2007 at 01:26:50PM -0500, Andy Holcomb wrote:
> Are the key short cuts in AXIS? like c,i,r and p?

http://linuxcnc.org/docs/html/gui/axis/index.html#SECTION00140000000000000000

    Keyboard Controls

    Almost all actions in AXIS can be accomplished with the keyboard. A full
    list of keyboard shortcuts can be found in the AXIS Quick Reference,
    which can be displayed by choosing HELP > QUICK REFERENCE. Many of the
    shortcuts are unavailable when in Code Entry mode. 

                    Table: Most Common Keyboard Shortcuts
        Keystroke           Action Taken
        =========           ============
        F1                  Toggle Emergency Stop
        F2                  Turn machine on/off
        `, 1 .. 9, 0        Set feed override from 0% to 100%
        X, `                Activate first axis
        Y, 1                Activate second axis
        Z, 2                Activate third axis
        A, 3                Activate fourth axis
        I                   Select jog increment
        C                   Continuous jog
        Control-Home        Perform homing sequence
        End                 Touch off: Set G54 offset for active axis
        Left, Right         Jog first axis
        Up, Down            Jog second axis
        Pg Up, Pg Dn        Jog third axis
        [, ]                Jog fourth axis
        O                   Open File
        Control-R           Reload File
        R                   Run file
        P                   Pause execution
        S                   Resume Execution
        ESC                 Stop execution
        Control-K           Clear backplot
        V                   Cycle among preset views

Jeff