#425 Tool Offset remap fails first time around

[Reinaldo Pena]

After remap of Txxyy. I noticed the offsets are not being applied correctly. It takes two commands instead of one. So basically it only applies the wear offset if the tool is already there.

Example:
-Machine is in Tx with offsets set
-Txxyy is commanded
-Tool changes to Txx but offset yy is not applied
-I command the same Txxyy again
-Now Tool offset yy is applied.

[Reinaldo Pena]

I set "Milestone: future-release" by mistake, it should be 2.6.7