Program pause/feed hold does not work properly when using G95 feed per revolution. When pressing Program pause during a feed move motion continues to programmed point, not stopping immediately like it should.
Thanks for bringing this to our attention. I assumed the wrong order of operations in tpGetRealTargetVel, so it ignored the pausing / aborting state during a synced move. This should now be fixed in master.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Which version of LinuxCNC are you using?
I am using master. Working on checking 2.6.1 now
It appears to work properly 2.6.1
This does work properly in 2.6.1, just test ran 2 programs, works fine.
Last edit: Rick Lair 2014-08-06
Hi Rick,
Thanks for bringing this to our attention. I assumed the wrong order of operations in tpGetRealTargetVel, so it ignored the pausing / aborting state during a synced move. This should now be fixed in master.