LinuxCNC / Archived Bugs / #310 erroneous backtracking with cutter comp

#310 erroneous backtracking with cutter comp

Status: open

Owner: nobody

Labels: None

Priority: 5

Updated: 2013-01-14

Created: 2013-01-14

Creator: Sebastian Kuzminsky

Private: No

In certain situations, cutter comp can cause erroneous backtracking.

Discussion

Sebastian Kuzminsky - 2013-01-14

bad-cutter-comp.png

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Sebastian Kuzminsky - 2013-01-14

broken.ngc

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Sebastian Kuzminsky - 2013-01-14

worse.ngc

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Sebastian Kuzminsky - 2013-01-14

worst-yet.ngc

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Sebastian Kuzminsky - 2013-01-14

Here's a brief discussion about the bug:

http://linuxcnc.mah.priv.at/irc/%23linuxcnc-devel/2013-01-14.html#20:08:23

If you would like to refer to this comment somewhere else in this project, copy and paste the following link: