LinuxCNC 2.5.1 - The Stepper Configuration Wizard documentation (docs/2.5/html/config/stepconf.html) refers to subdirectory emc2 instead of linuxcnc
"Stepconf places a file in the emc2/config directory to store...."
Also, three figures in this document---latency.png, stepconf-basic.png, and step-config.png---refer to EMC or emc2 instead of LinuxCNC.
I tried to upload a file, stepconf-figures-rebranded.tar.gz, containing the new figures but it was too big (>400Kb) for SourceForge (limit: 256Kb). Instead I uploaded it to http://www.mediafire.com/download.php?d6wtu9b41xdmtdu
Note that this tarball contains all the figures presented by stepconf and not just the two mentioned above. Also it contains two versions of the latency figure---latency-lc.png which says "linuxcnc" (lowercase) and latency-ulc.png which says "LinuxCNC" (up/low case) since I didn't know how latency-test would be changed.
Regards,
Kent
Fixed, thanks for the bug report.