The parameters of pulse in elk.in are set as follows:
! laser pulse parameters
! 1 - 3 : polarisation vector (including amplitude)
! 4 : frequency
! 5 : phase in degrees
! 6 : chirp rate
! 7 : peak time
! 8 : full-width at half-maximum
pulse
1 : number of laser pulses
30 0.0 0.0 0.06 0.0 0.0 500 250
After calculation, the output fluence is 13.95 mJ/cm2. I would like to know which parameters control the fluence (mJ/cm2) of incident laser pump if I want to increase the fluence.
Thanks for all
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Dear All,
The parameters of pulse in elk.in are set as follows:
! laser pulse parameters
! 1 - 3 : polarisation vector (including amplitude)
! 4 : frequency
! 5 : phase in degrees
! 6 : chirp rate
! 7 : peak time
! 8 : full-width at half-maximum
pulse
1 : number of laser pulses
30 0.0 0.0 0.06 0.0 0.0 500 250
After calculation, the output fluence is 13.95 mJ/cm2. I would like to know which parameters control the fluence (mJ/cm2) of incident laser pump if I want to increase the fluence.
Thanks for all
This is the incident fluence. You can increase by increasing the amplitude of FWHM of the pulse.
Dear Sangeeta,
Thank you! I will try it.