Enabling VA Services after initial deployment

Help
fin358ile
2014-02-04
2015-07-02
  • fin358ile

    fin358ile - 2014-02-04

    Hi,

    I have EJBCA running, but without VA services (CA certificate store) as did not understood to enable it while compiling. Now there seems to be need for VA services. Is there a solution to active this service ? Doc says can be "enabled at compile time" ? That wipes out existing DB and configurations ? I Would not like to install separate VA instance.

    http://ejbca.org/services-va.html#CA%20certificate%20store
    VA Services
    The validation authority (VA) module of EJBCA provides services used to validate a certificate. These services can run on an installed EJBCA or on a standalone VA installation. Each service can be enabled/disabled independently at compile time. The services are disabled by default.

     
    Last edit: fin358ile 2014-02-04
  • Tomas Gustavsson

    It does not wipe anything Just configure and redeploy (ant deployear).

    re you sure it is the RFC 4387 certificate and CRL download services you need?

    Cheers,
    Tomas


    PrimeKey Solutions offers commercial EJBCA and SignServer support subscriptions and training courses. Please see www.primekey.se or contact info@primekey.se for more information.
    http://www.primekey.se/Services/Support/
    http://www.primekey.se/Services/Training/

     
  • ta anh thai

    ta anh thai - 2015-07-02

    Hello.
    I has a problem about setup VA sevices.I dont know How install VA services?
    You worked with VA services ,Can you help me install VA on ejbca?

    Thank you so much

     

Log in to post a comment.