Copper layer top/bottom not shown if inside part

Import your PCB boards to FreeCAD

Status: Beta

Brought to you by: marmni

Copper layer top/bottom not shown if inside part

Forum: Help

Created: 2021-07-21

Updated: 2021-07-28

SeB30 - 2021-07-21

Hi,
I have a Eagle part made only of copper (PCB antenna, ...), when imported, only pad are shown, not copper.
Other top/bottom copper (routed track) are ok.
Thanks for this great tool.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
- Anonymous
  
  Add attachments
  Cancel
  You seem to have CSS turned off. Please don't fill out this field.
  
  You seem to have CSS turned off. Please don't fill out this field.

Mariusz - 2021-07-28

Hi,
check version from github (master).

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
- Anonymous
  
  Add attachments
  Cancel
  You seem to have CSS turned off. Please don't fill out this field.
  
  You seem to have CSS turned off. Please don't fill out this field.

SeB30 - 2021-07-28

Hi, forgot to say I was on FreeCAD 0.18.
Now upgraded to 0.19.2.7b5e18a-WIN-x64 with fresh version from GitHub and it works !
My RFID coil antenna as copper visible in 3D.
thanks again.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
- Anonymous
  
  Add attachments
  Cancel
  You seem to have CSS turned off. Please don't fill out this field.
  
  You seem to have CSS turned off. Please don't fill out this field.

Anonymous