Hi,
I'm able to reproduce a similar condition, where the ending y.position on
one layer is 10 greater than what it should be, and the ending x position of
another layer is 21 less than what it should be, both when specifying 'fast'
as an endSpeed. Also, even when specifying slow as both startSpeed and
endSpeed, I noticed the ending x position of the second layer was 1 less
than it should be. (1 and 21). When specifying multiple GlideAnimations to
construct a path, the intermediate paths seem correct, it's just the final
path seems to get corrupted somehow.
Staring at the src/fx/glideanim.js and putting in alerts here and there to
check values, I'm still not sure where or why the error is occuring. I
haven't done an indepth search for the errors though (i.e. alerts on every
line :^) .
Leif
P.S. I am using the code from the chaining of events example from yesterday.
----- Original Message -----
From: "Zhichun Pu" <s4...@st...>
To: <dyn...@li...>
Sent: Saturday, July 19, 2003 3:53 AM
Subject: [Dynapi-Help] Possible Bug...
> Hey guys,
>
> So for the Glideanimation, it seems that when you end the speed at "fast",
> the layer will stop short of the destination. That is, it won't *quite*
> reach there, but stop sometimes before reaching it or over-reach.
>
> For example:
>
> GlideAnimation(0,400,0,50,1,'slow','slow')
>
> is different than
>
> GlideAnimation(0,400,0,50,1,'slow','fast')
>
> The second line ends with a fast speed, and it won't quite teach 50. In my
> case, it overreached and went to some place like 10. It refuses to go to
> places below 10.
>
> Anyway, is this a bug or am I doing something wrong?
>
> Steven
>
>
>
> -------------------------------------------------------
> This SF.net email is sponsored by: VM Ware
> With VMware you can run multiple operating systems on a single machine.
> WITHOUT REBOOTING! Mix Linux / Windows / Novell virtual machines at the
> same time. Free trial click here: http://www.vmware.com/wl/offer/345/0
> _______________________________________________
> Dynapi-Help mailing list
> Dyn...@li...
> https://lists.sourceforge.net/lists/listinfo/dynapi-help
>
>
|
