may I ask your help to understand what's wrong with the attached model?
When run DWSim returns me the error CSTR01: Sequence contains no elements.
It should work instead (on other simulator it does) with a conversion of approx 61% on nC4.
Another questiom: in the reaction kinetic dialog,, how to specify that in the DO and in the RO reactions the base component is the reactant?
Hi Daniel and everyone in this forum,
may I ask your help to understand what's wrong with the attached model?
When run DWSim returns me the error CSTR01: Sequence contains no elements.
It should work instead (on other simulator it does) with a conversion of approx 61% on nC4.
Another questiom: in the reaction kinetic dialog,, how to specify that in the DO and in the RO reactions the base component is the reactant?
Thanks in advance for any suggestion.
Luca
Funny thing is, if you change the reactor from Adiabatic to Isothermal it works fine.
Thanks for noting that, Frank; I did not realize it ... Could this imply convergence issues on PH flash in adiabatic?
Check the amount of heat released in isothermic mode and try adding it to the inlet stream to see the magic happening (or not).