In the problem image you can see that I cannot access pipe length property for sensitivity analysis. Is there anything to replicate this HYSYS feature: http://www.mediafire.com/file/19h3eivbn1nqg4n/HYSYS_Out.png
In the image data recorder was used to log/capture changing exit velocities for increasing pipe lengths
Note: DWSIM Results shown only 2-3% difference when compared with HYSYS results (insignificant for plant design) ...so good job anyway
*Chosen because the line size is 1inSc40 25m (air)
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I have setup sim to determine exit velocities of air for changing Pipe Lengths (a system devised to surrogate our air compressor system)
Sim Setup (PR + Brills Correlation for pressure drop*): http://www.mediafire.com/view/a3agdnf4kasrah4/Screenshot_2.png#
Problem: http://www.mediafire.com/view/mwn75058edd51w5/Screenshot_1.png
In the problem image you can see that I cannot access pipe length property for sensitivity analysis. Is there anything to replicate this HYSYS feature: http://www.mediafire.com/file/19h3eivbn1nqg4n/HYSYS_Out.png
In the image data recorder was used to log/capture changing exit velocities for increasing pipe lengths
Note: DWSIM Results shown only 2-3% difference when compared with HYSYS results (insignificant for plant design) ...so good job anyway
*Chosen because the line size is 1inSc40 25m (air)
Thanks problem resolved with v5.1u9