Hi,
I have attached dsp file of my system and system data. I am not getting results as in the paper, not even close!!. I dont know what mistakes i have done. P and Q of both DGs are 43.5kW and 28.35kVAR respectively. Please help
Well I've checked your DSSim project and changed a couple of things. I've defined the voltage bases in the file Ctrl_Proj.dss and then, associated this file as DSS control file to the project (check the Introduction video).
When running your project do the following:
Open the project using DSSim-PC
select Simulator->Compile project
Select Meters->Load meter File
Select the file "Meters_file"
The first values are for when the switches are open, for changing the state of the switches select simulator->initiate simulation. There, select the time based simulation and the parameters that you prefer. The select the option Project->Control switches. You will see how your values change.
Thank you for ur detailed reply!
I have a strange problem. Trust me. Its Not jus mine!!
I have built a one line diagram using DSSim-PC and ive run it succesfully without any issues. But now its behaving strange! When im trying to "OPEN" my dsp file the software gets closed immediately. I tried in two PCs. Same experience! Any idea? I am using DSSim-PC V1.1(f1.1.9). Thank You
Last edit: MUHAMMED FASIL T.P. 2015-01-30
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi,
I have attached dsp file of my system and system data. I am not getting results as in the paper, not even close!!. I dont know what mistakes i have done. P and Q of both DGs are 43.5kW and 28.35kVAR respectively. Please help
Hi,
Well I've checked your DSSim project and changed a couple of things. I've defined the voltage bases in the file Ctrl_Proj.dss and then, associated this file as DSS control file to the project (check the Introduction video).
When running your project do the following:
The first values are for when the switches are open, for changing the state of the switches select simulator->initiate simulation. There, select the time based simulation and the parameters that you prefer. The select the option Project->Control switches. You will see how your values change.
Best regards
Davis
Hi Davis,
Thank you for ur detailed reply!
I have a strange problem. Trust me. Its Not jus mine!!
I have built a one line diagram using DSSim-PC and ive run it succesfully without any issues. But now its behaving strange! When im trying to "OPEN" my dsp file the software gets closed immediately. I tried in two PCs. Same experience! Any idea? I am using DSSim-PC V1.1(f1.1.9). Thank You
Last edit: MUHAMMED FASIL T.P. 2015-01-30