#4 multiple firmware loads fail.

[psilva]

If you perform a firmware upgrade. The first one will succeed. drobo is rebooted with new firmware. Then immediately attempt
to upgrade again. This occurs, say if you find a drobo with very old firmware, it will not move directly to the latest version
but step up as follows:

1.0.3 -> 1.1.2 -> 1.3.0 -> 1.3.5

The complete upgrade cycle, in this case, will require 4 fw upgrade cycles.
When upgrades are done too quickly together, the second upgrade will "succeed" too quickly, in that the progress zips by, but it does not,
in reality, work correctly. Rebooting will just have you reboot the same firmware.

Just wait a few minutes, and try the firmware load again. It will proceed normally.