Re: [Drbl-user] Need Help with DRBL/Clonezilla errors

[Raj V. <drb...@i2...>]

Dear Steven: Thanks..
I ran "cat /proc/partitions" on client and it did not show me anything so you were right about the kernel it was pushing did not see my SCSI drives.
So I ran "drblsrv -i" on server and configured the SAME kernel of my server to client and it worked (my client and server are 100% same HW specs)

I can SAVE and RETORE the disks from clients, everything working for LINUX clients cloning/restore and windows clone/backup only.

Now another two main problem I am facing for windows restore:

1) When I restore my Windows 2000 Sever image to SAME HARDWARE, NEW Hard drive of 100% same specs.
It restores and when windows boot screen comes on with progress bar i get 
Blue screen which says
------------------------
"*** STOP: 0x0000007B (0x818B51B0, 0xC00000010, 0x00000000,0x00000000)
INACCESSIBLE_BOOT_DEVICE
If this is the first time you've seen this Stop error screen, restart your computer. If this screen appears again, follow these steps:

Check for viruses on your computer. remove any newly installed 
hardware or hard drive controllers. Check your hard drive 
to make sure it is properly configured and terminated.
Run CHKDSK /F to check for hard drive corruption and then
restart your computer,
---------------------------

I tried restoring with DD method [-j0 Use dd to create partition table instead of sfdisk ]
but same error.

2) Then i tried SYSPREP for windows to eliminate PC info and during CLONING it get error/warning NTFS is corrupted [my windows install is not corrupted as the original install boots and just fine and no errors in windows]

Then restoring from the SYSPREP image also i get same error above.

Any pointers if i can try some option in restore. If i pick [-j0] option do i need the TOP option of GURB also or not.

Sorry for asking so many questions but i really like  your software and trying my best to use it on our network.

Thanks again.
Raj