When I started clonezilla server the first time it asked for configuration information. I entered some incorrect info and there was no way to go back. Now when I click the icon to start the clonezilla server it starts from where I was last at???
So I cannot correct the mistakes. It's driving me insane!!!! I have the same issue with clonezilla live! If you make a mistake there is no way to go back and correct it???
There has to be a cfg file or switch to tell them to start fresh or at leaswt I hope there is.
Can someone please help?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Did you use DRBL live? If so, it's easier to reboot it then restart the Clonezilla SE jobs.
Or you can use the "lite server" in Clonezilla live (>=2.5.2-17 or 20170626-*), and everytime if you need to fix something, you can just re-run the whole command (which is prompted in green) and of course, fix the parameters in the command.
Steven
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
When I started clonezilla server the first time it asked for configuration information. I entered some incorrect info and there was no way to go back. Now when I click the icon to start the clonezilla server it starts from where I was last at???
So I cannot correct the mistakes. It's driving me insane!!!! I have the same issue with clonezilla live! If you make a mistake there is no way to go back and correct it???
There has to be a cfg file or switch to tell them to start fresh or at leaswt I hope there is.
Can someone please help?
Did you use DRBL live? If so, it's easier to reboot it then restart the Clonezilla SE jobs.
Or you can use the "lite server" in Clonezilla live (>=2.5.2-17 or 20170626-*), and everytime if you need to fix something, you can just re-run the whole command (which is prompted in green) and of course, fix the parameters in the command.
Steven