Where in the ACM files can i find the values of the setup
parameters like frequency,symbol rate,channels,filters ..
I have 2-way system with white dish.
Take your Satmodem and plug it into a windows box (no,
seriously - you have to go through a registration process to
activate the modem - the commercial drivers from Helius have
the same requirement)
Install the windows drivers and complete the registration
process. While you're at it, dial up and test the Satmodem.
Make sure you can at least browse web pages and download
via the satellite. If you can't get your account working under
windows, harrass your provider's support desk until you can.
In C:\Program Files\DirecPC\Bin there will be a number of
*.ACM files save these (particularly KEYRSP.ACM and
PARAMRSP.ACM) they contain the setup info for your
service - including the Satmodem config.
Open the properties for the Antenna Pointing shortcut.
add /MANUAL to the command line, click OK, then run the
Antenna Pointing app. You now have a new second page -
write down the settings on both tabs of this page.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
the softeware for the two ways system doesn't allow you to
add the /MANUAL switch, so any ideas on how to do it for
that? There are details for US and Australian satellites but
not for Europe.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Logged In: NO
Take your Satmodem and plug it into a windows box (no,
seriously - you have to go through a registration process to
activate the modem - the commercial drivers from Helius have
the same requirement)
Install the windows drivers and complete the registration
process. While you're at it, dial up and test the Satmodem.
Make sure you can at least browse web pages and download
via the satellite. If you can't get your account working under
windows, harrass your provider's support desk until you can.
In C:\Program Files\DirecPC\Bin there will be a number of
*.ACM files save these (particularly KEYRSP.ACM and
PARAMRSP.ACM) they contain the setup info for your
service - including the Satmodem config.
Open the properties for the Antenna Pointing shortcut.
add /MANUAL to the command line, click OK, then run the
Antenna Pointing app. You now have a new second page -
write down the settings on both tabs of this page.
Logged In: NO
the softeware for the two ways system doesn't allow you to
add the /MANUAL switch, so any ideas on how to do it for
that? There are details for US and Australian satellites but
not for Europe.