digimend-devel

[DIGImend-devel] Ugee g3 diagnostic

[Alberto González-B. N. <al...@gm...>]

Hi

I just send a pull request with the diagnostic and descriptor for the ugee
g3 tablet. The ugee g3 has different PID (3031) from others ugee tablet.


I read in the mailing list that some other users have had luck using the
evdev drivers in some Ugee tablets, but I have not managed to make it work.

-- 
Alberto

Re: [DIGImend-devel] Ugee g3 diagnostic

[Nikolai K. <sp...@gm...>]

Hi Alberto,

On 05/04/2015 03:14 AM, Alberto González-Barreda Naranjo wrote:
> I just send a pull request with the diagnostic and descriptor for the ugee g3 tablet. The ugee g3 has different PID (3031) from others ugee tablet.

Thanks for sending this in! I'll take a look at it during this week.

> I read in the mailing list that some other users have had luck using the
> evdev drivers in some Ugee tablets, but I have not managed to make it work.

You'll need the kernel support for it as well, most likely.

In the mean time you can try getting some data out of it with uclogic-tools
[1] and if that works, then adding your tablet VID:PID into all appropriate
places in digimend-kernel-drivers [2] and checking if that would work.

Nick

[1] https://github.com/DIGImend/uclogic-tools
[2] https://github.com/DIGImend/digimend-kernel-drivers

Re: [DIGImend-devel] Ugee g3 diagnostic

[Alberto González-B. N. <al...@gm...>]

Hi Nikolai,


> In the mean time you can try getting some data out of it with uclogic-tools
> [1] and if that works,


I tried Uclogic and it output some data (max x, max y, manufacturer,
pressure, resoluton and button status; internal model is blank)


> then adding your tablet VID:PID into all appropriate
> places in digimend-kernel-drivers [2] and checking if that would work.
>
>
Yes I did it, I forgot to mention in the previous mail, I tried before and
it didn't work, but in case I made any mistake I tried again and now the
tablet did work. I haven't tested that much but it seems everything works.

I will send a pull request with the changes.


Thaks for the help

-- 
Alberto