Re: [Devmon] Can someone send the steps for adding a new device type and MIB to snmp & devmon?

[W.J.M. N. <Wim...@nl...>]

On 01/25/2013 06:29 PM, Don Kuhlman wrote:
> Hi folks. I'm not getting emails from the list so I'm looking into that. So I apologize that this thread had answers (Ken, Jeremy, etc) but thanks for the replies.
>
> ......
>
>
> OIDS file:
>
>
>
> VolName         : .1.3.6.1.4.1.24681.1.2.17.1.2 : branch
> VolFileSystem   : .1.3.6.1.4.1.24681.1.2.17.1.3 : branch
> VolSize         : .1.3.6.1.2.1.24681.1.2.17.1.4 : branch
> VolFree         : .1.3.6.1.2.1.24681.1.2.17.1.5 : branch
> VolStatus       : .1.3.6.1.2.1.24681.1.2.17.1.6 : branch
There is an error in last three OIDs, which can explain the error message 
below.
> This piece doesn't work - it's giving the "missing repeater data for primary OID VolName"
>
>
>
> TABLE:plain
> Volume|Filesystem|Capacity|Available|Status
> {VolName}|{VolFileSystem}|{VolSize}|{VolFree}|{VolStatus}

HTH,
   Wim Nelis.




******************************************************************************************************************

The NLR disclaimer is valid for NLR e-mail messages.

This message is only meant for providing information. Nothing in this e-mail message amounts to a contractual
or legal commitment on the part of the sender.
This message may contain information that is not intended for you. If you are not the addressee or if this
message was sent to you by mistake, you are requested to inform the sender and delete the message.
Sender accepts no liability for damage of any kind resulting from the risks inherent in the electronic
transmission of messages.
 
******************************************************************************************************************