[Devmon] Missing SNMP's on some server

[<kri...@th...>]

Good afternoon,
 
We've been using devmon quite some while now, and during we created our
own custom templates for hp servers, cisco ios's etc...
 
However, we are expiriencing some issues for which I require a fresh set
of eyes.
 
1st problem:
For some hp servers (like bl35p or dl585 g5), most of the OIDS which
normally work are not available. I've located the MIBS on the server
itself under /user/share/snmp/mibs, and tried to update them but they
aren't accepted.
The strange thing is, is that we some devices which are configured
identically (same hardware, software, hp health agents etc.) are working
perfectly, while other with the same configuration don't have the OIDS
available; (even with manual snmpwalk)
 
2nd problem:
We've created a hphealth agent test (with some additional stuff to
monitor outside of the regular compaq testing). This test contains
branches (regarding phy drives and memory etc...) but sometimes, devmon
does not see the results as a branch which leads to the 'missing
repeater data for...' message. For other servers with same config, they
are working and recognized fine.
All tests which are after that specific test, altough they are working,
are not executed anymore and no results are displayed.
 
We also tried to use the devmon templates on sourceforge for compaq
devices, but the results are not different.
 
Does anyone expirienced a similar issue as above and solved it? Or know
why it is caused like that?
 
Thanks a lot
 
and of course, if somebody would like a template, I can send it over ;-)
 
Kind regards,
Met vriendelijke groet, 

Kristof Van Den Ouweland