Hi Serge,

On 02/24/2012 11:34 PM, Serge Leschinsky wrote:
I assume you are in DL.

cd /tmp/
cp /boot/initrd.gz ./
gzip -d initrd.gz
mkdir 123
cd ./123
cpio -id < ../initrd
mkdir lib/modules/3.2.4-grsec/kernel/drivers/pci
cp -ar /lib/modules/3.2.4-grsec/kernel/drivers/pci/hotplug 
find . | cpio -H newc -o | gzip -9 > ../initrd.gz

then replace old initrd.gz file on your boot media (/dev/sdb) by new one

Thanks for the instructions, but even after replacing the initrd, I had no luck getting the mSATA drive recognised on boot.

I also added pci_hotplug to the /etc/sysconfig/config INITRD parameter without success.

Was there anything else I needed to do to get this recognised (if it was the hotplug module) or any other way of finding what module is required?