Re: [ddccontrol-users] PCI-E and Nvidia 6200TC

[Jarek L. <ja...@ne...>]

>Thanks for your bug report.

>I just commited a fix for this problem. It should be available in the
>anonymous CVS in a couple of hours.

The fix seems to work. It still outputs some, what seems to be, errormessages:

$ gddccontrol
Xinerama not supported
Device: pci:01:00.0-0
Error while reading write message answer: Bad message
Reading EDID 0x50 failed.
Device: pci:01:00.0-1
Error while reading write message answer: Bad message
Reading EDID 0x50 failed.
Device: pci:01:00.0-2
dev:/dev/i2c-7: No such device or address
Be sure you've modprobed i2c-dev and correct framebuffer device.
dev:/dev/i2c-6: No such device or address
Be sure you've modprobed i2c-dev and correct framebuffer device.
dev:/dev/i2c-5: No such device or address
Be sure you've modprobed i2c-dev and correct framebuffer device.
dev:/dev/i2c-4: No such device or address
Be sure you've modprobed i2c-dev and correct framebuffer device.
dev:/dev/i2c-3: No such device or address
Be sure you've modprobed i2c-dev and correct framebuffer device.
dev:/dev/i2c-2: No such device or address
Be sure you've modprobed i2c-dev and correct framebuffer device.
dev:/dev/i2c-1: No such device or address
Be sure you've modprobed i2c-dev and correct framebuffer device.
dev:/dev/i2c-0: No such device or address
Be sure you've modprobed i2c-dev and correct framebuffer device.
currentid(-1) != nextid(0), trying...
Device: pci:01:00.0-2
i2c-algo-bit.o: readbytes: i2c_inb timed out.
Error while reading read message answer: Bad message
currentid == nextid (0)

But the monitor is detected, the gui starts and you can change and save some things 
(brightness, contrast) and revert to factory settings. The "Magic Bright Mode" I can't 
seem to save, though I don't know what it is so it doesn't matter.

Thank you for the amazingly fast response on my post btw.

Regards,
Jarek