Re: [ddccontrol-users] Some problems with start

[Nicolas B. <ni...@bo...>]

Hi,

It seems you don't have the ddccontrol-db package installed, could you
fetch it, and install it (with "./configure", then "make install")?
I think it will solve your problem.

Best regards,

Nicolas Boichat

On Sun, 2004-11-21 at 15:40 +0300, Konstantin Abramenko wrote:
> Hi all, 
> 
> I have Samsung 173P and try to use this packet to control it. 
> 
> With some magic actions I've built it :), but it does not work correctly. 
> 
> As I understand, main tool is ddccontrol. It fails.
> I can to study doc/xml-design.txt and try to write correct XML file for my monitor, but I have no yet any thoughts - why it do not see device. 
> 
> stderr stream of `sudo ddccontrol -p` was the following: 
> 
> ==========================
> Error while reading write message answer: Bad message
> Reading EDID 0x50 failed.
> I/O warning : failed to load external entity "/usr/local/share/ddccontrol-db/monitor/SAM00D3.xml"
> Document not parsed successfully. 
> ioctl(): Function not implemented
> ioctl returned -1
> Reading EDID 0x50 failed.
> ioctl(): Function not implemented
> ioctl returned -1
> Reading EDID 0x50 failed.
> dev:/dev/i2c-2: No such device
> Be sure you've modprobed i2c-dev and correct framebuffer device.
> dev:/dev/i2c-3: No such device
> Be sure you've modprobed i2c-dev and correct framebuffer device.
> dev:/dev/i2c-4: No such device
> Be sure you've modprobed i2c-dev and correct framebuffer device.
> dev:/dev/i2c-5: No such device
> Be sure you've modprobed i2c-dev and correct framebuffer device.
> dev:/dev/i2c-6: No such device
> Be sure you've modprobed i2c-dev and correct framebuffer device.
> dev:/dev/i2c-7: No such device
> Be sure you've modprobed i2c-dev and correct framebuffer device.
> I/O warning : failed to load external entity "/usr/local/share/ddccontrol-db/monitor/SAM00D3.xml"
> Document not parsed successfully. 
> ===========================
> 
> 
>