Hello,
(please also cc the list)
Selon vv vv <vv...@bk...>:
>
>
>
> > However it won't be a problem to add an entry in the database for this
> monitor.
>
>
> In file "monitor/SAM00D3.xml" I want write:
> "<?xml version="1.0"?>
> <!--- CA and E1 are supported but not reported by CAPS (OSD and power,
> <monitor name="Samsung SyncMaster 173P PLUS (VGA)" init="standard">
> <controls>
> ..."
> Is it all what need? Or need greate new file(for 173 PLUS) and ./congigure,
> make ...?
In fact you'll need to copy 173P xml file to a new one: monitor/SAMxxxx.xml,
where xxxx is the EDID id of your monitor (it is not a problem to get this id
once you have the monitor).
> > time to test it (note you don't have to have a monitor supporting DDC/CI to
> test
> > it), please send me the output of "lspci -v -v" (run it as root).
> >
>
>
> Ok..
>
> [snip]
>
> 0000:00:02.0 VGA compatible controller: Intel Corporation 82865G Integrated
> Graphics Controller (rev 02) (prog-if 00 [VGA])
> Subsystem: Elitegroup Computer Systems: Unknown device 1867
> Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
> Stepping- SERR- FastB2B-
> Status: Cap+ 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=fast >TAbort- <TAbort-
> <MAbort- >SERR- <PERR-
> Latency: 0
> Interrupt: pin A routed to IRQ 10
> Region 0: Memory at f0000000 (32-bit, prefetchable)
> Region 1: Memory at fa000000 (32-bit, non-prefetchable) [size=512K]
> Region 2: I/O ports at b000 [size=8]
> Capabilities: [d0] Power Management version 1
> Flags: PMEClk- DSI+ D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
> Status: D0 PME-Enable- DSel=0 DScale=0 PME-
>
> [snip]
Thanks. Please replace src/ddcpci/intel855.c by the file I attached, then run
"make" AND "make install" again, and finally try to run "ddccontrol -v -v -p",
and send me the output.
Best regards,
Nicolas |
