#33 Seg fault when running racl or acl commands

[Anonymous]

When i run the command cvs -d /cvs/project1/ racl -l and point it to no directory or file i get a segmentation fault. the strace output is below.

---begin strace---
access("/cvs/project1/CVSROOT", R_OK|X_OK) = 0
open("/cvs/project1/CVSROOT/config", O_RDONLY|O_LARGEFILE) = 3
fstat64(3, {st_mode=S_IFREG|0444, st_size=4082, ...}) = 0
mmap2(NULL, 4096, PROT_READ|PROT_WRITE, MAP_PRIVATE|MAP_ANONYMOUS, -1, 0) = 0xb7f77000
read(3, "# Set `SystemAuth\' to `no\' if ps"..., 4096) = 4082
read(3, "", 4096) = 0
close(3) = 0
munmap(0xb7f77000, 4096) = 0
open("/cvs/project1/CVSROOT/aclconfig", O_RDONLY|O_LARGEFILE) = 3
fstat64(3, {st_mode=S_IFREG|0444, st_size=1565, ...}) = 0
mmap2(NULL, 4096, PROT_READ|PROT_WRITE, MAP_PRIVATE|MAP_ANONYMOUS, -1, 0) = 0xb7f77000
read(3, "# CVS Access Control Extension c"..., 4096) = 1565
read(3, "", 4096) = 0
close(3) = 0
munmap(0xb7f77000, 4096) = 0
--- SIGSEGV (Segmentation fault) @ 0 (0) ---
+++ killed by SIGSEGV +++

---end strace---

When i run the command cvs -d /cvs/project1/ racl -l src and i then either point it to a directory or file it does not result in a segmentation fault. It ends withh good output like below.

d src | HEAD | | defaults ALL:

There has got to be a reason why were are getting a segmentation fault when we leave off the file or folder at the end of the command. Is the error logging not built out to handle this?

thoughts??