I am getting a seg fault (signal 11) from tide-index when running the performance tests in the current trunk. Can anyone successfully run the performance test?
Just ran performance tests on my mac and linux. Logs are attached below. Linux does not seem to have any problems, mac only errored during gnuplot since I don't have it installed.
Never mind this. I couldn't reproduce it. It seems to have been a product of an incomplete build or mismatched versions in the build.
Incidentally, doing a deep-clean did not fix the problem. The only way to fix it was to entirely delete my build directory and start over from scratch. This implies to me that maybe our "deep-clean" is not deep (or clean) enough!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Just ran performance tests on my mac and linux. Logs are attached below. Linux does not seem to have any problems, mac only errored during gnuplot since I don't have it installed.
Never mind this. I couldn't reproduce it. It seems to have been a product of an incomplete build or mismatched versions in the build.
Incidentally, doing a deep-clean did not fix the problem. The only way to fix it was to entirely delete my build directory and start over from scratch. This implies to me that maybe our "deep-clean" is not deep (or clean) enough!