Hi, I'm just getting started with com0com and having a problem.
I installed on Windows XP SP3 32 bit . Install went fine, no errors.
But when I look at device manager, the com0com serial port emulator entries have the yellow exclamation mark and properties for that device says "This device is not configured correctly. (Code 1)".
Hyperterminal does not see the new virtual ports.
A reboot did not help.
Can anyone advise how I can fix this?
Thanks,
Pete
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hi, I'm just getting started with com0com and having a problem.
I installed on Windows XP SP3 32 bit . Install went fine, no errors.
But when I look at device manager, the com0com serial port emulator entries have the yellow exclamation mark and properties for that device says "This device is not configured correctly. (Code 1)".
Hyperterminal does not see the new virtual ports.
A reboot did not help.
Can anyone advise how I can fix this?
Thanks,
Pete
Possible problem with PNP service or PNP wait Administrator logon.
Enter to system as Administrator or try (with the Setup Command Prompt:):
command> update