Hi,
I have tried to get IPv6 up and running with cL in bridged mode, but cL
doesn't get the IPv6 address from the autoconfiguration (based on the
IPv6 prefex broadcasted by the router). The routing-table is set
allright (correct prefix is in the routing table for IPv6), but the
IPv6-address is'n related to the eth0. The console reports:
conet0: initialized
IPv6 v0.8 for NET4.0
IPv6 over IPv4 tunneling driver
eth0: duplicate address detected!
IPv4 works fine, tcpdump for IPv6 traffic works fine too (I can see
broadcasts) but the eth0 doesn't get the right IPv6 address. As far as I
know WinPCAP is already in promiscious mode (cL network mode is bridged)
and should therefore already receive the (IPv6-) packets with the
prefix. The desktop is running IPv6 and that is on autoconfiguration.
Anyone who has this up and running, I use a adapted kernel + modules
from Matus Horvath.
Best Regards,
Bart
|
