clonezilla restore image - no boot devices found
A partition and disk imaging/cloning program
Brought to you by:
steven_shiau
Menu
▾
▴
I have been using clonezilla fine until today. I am unable to image a computer - dell 7050. It is usuing m.2 flash drive. We have had these computers before with no problems. But the new batch images everything and on the reboot I get no bootable devices found.
I am not sure where to go to troubelshoot this issue . Any advice on how to figure this out. Where is the log file kept ? I was running this via ssh.
Last edit: mmoore5553 2018-03-19
i am using the newest clonezilla bionic. I also checked bios and I have achi enabled.
Last edit: mmoore5553 2018-03-19
You might want to try to enable Legacy (MBR) boot mode in the BIOS. If the original system of which you created the image is installed in Legacy boot mode (and has a MBR bootable partition instead of GPT), the system won't see a bootable device if Legacy boot mode is disabled and it can only boot in UEFI mode. That's the only thing I can think of.
rats. That is what I did , enable legacy , and it said no boot device. It is only on this model. So strange.
The disk doesn't show up in the list of bootable devices when you press F12 during POST?