I used "alternative stable - 20250303-oracular"
I started cloning from disk to disk, but decided to interrupt the process due to very low speed, choose other settings (previously created a clone of the same disk much faster). At the time of interruption, about 2% was completed, after i stopped process.
Subsequently, I was unable to start cloning and cannot initialize the disk in disk management.
The disk is not initialized, shows the full amount of unallocated memory. UUID is 000000000000000000. The disk is detected normally - model and firmware. I tried to use different utilities to restore the partition table - but without success. Surface tests with reading show that the disk is OK, but all write tests failed. The Kingston KC3000 disk on the FISUN PS5018 controller, I can not find a utility for firmware and disk recovery, the original Kingston software does not see the disk.
Is there any way to manually restore the partition table?
Hello everyone.
I used "alternative stable - 20250303-oracular"
I started cloning from disk to disk, but decided to interrupt the process due to very low speed, choose other settings (previously created a clone of the same disk much faster). At the time of interruption, about 2% was completed, after i stopped process.
Subsequently, I was unable to start cloning and cannot initialize the disk in disk management.
The disk is not initialized, shows the full amount of unallocated memory. UUID is 000000000000000000. The disk is detected normally - model and firmware. I tried to use different utilities to restore the partition table - but without success. Surface tests with reading show that the disk is OK, but all write tests failed. The Kingston KC3000 disk on the FISUN PS5018 controller, I can not find a utility for firmware and disk recovery, the original Kingston software does not see the disk.
Is there any way to manually restore the partition table?
There was an I/O error shown in the photo you provided.
Not sure if it's a hardware issue.
Have you tried to power off the machine then try it again?
Steven