Clonezilla Live imaging issue with windows 10
A partition and disk imaging/cloning program
Brought to you by:
steven_shiau
Menu
▾
▴
I have configured a windows 10 image then run sysprep /oobe /generalize /shutdown then boot up to clonezille and create the image.
I am having an issue where I can create an image and the image appears to apply properly, then boots up to the settings screens to select region, timezone, etc. I skip the page for entering the product key, accept the EULA, I choose to use the express settings, it spins for a couple of minutes then reboots to the same settings screen all over again. I have tried entering a product key to see if that was throwing it off, as expected that had no effect. Not sure why it will not go beyond this point, any ideas are welcomed.
Last edit: Bill Spencer 2017-02-09
Maybe it's the driver issue? Is the source machine very different from the destination machine?
Steven