Fail to recognize to image for Restoration
A partition and disk imaging/cloning program
Brought to you by:
steven_shiau
Menu
▾
▴
Recently i have created an image of a entire disk using Clonezilla for 2 system. I used a thumbdrive to boot and launch Clonezilla and save the image to an external USB hardisk. The problem is when restore the image it works perfectly fine for this 1st image however clonezilla cannot recognize the 2nd image when i choose restore instead of providing 2 choice of image to restore from it only prompt the 1st image. Even if i try to move to content of the 1st image into a different location the clonezilla will prompt no image in the hardisk. How do i verify if the 2nd image i created is valid and its not corrupted is there any command manually that i can run to verify the image from the Clonezilla command prompt
What is your 2nd image type? For disk or for partition?
Make sure you do not try to restore a "partition type" of image to a disk by "restoredisk". In this case, you should use "restoreparts".
Steven.