I am trying to clone a HD from HP Digital Sender 9250C. I have tried a couple of local disk to local disk configiuations, but I keep getting the same error messages. I am guessing that I have something configured wrong or it just can't be done. I am using Clonxilla Live 20150805-vivid-i386.
The error message is "unknown partition table format for file /temp/ocs_onthefly_local.pPerfOG/src-pt.parted!".
Is there a command line to do a disk to disk copy and ignore errors or is this not able to be doner? Could my destination drive be bad?
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Could you please run these commands in the Clonezilla live command line prompt:
1. sudo -i
2. parted -s /dev/sda print
3. blkid
4. cat /proc/partitions
Please post the results of 2-4.
Steven.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I am trying to clone a HD from HP Digital Sender 9250C. I have tried a couple of local disk to local disk configiuations, but I keep getting the same error messages. I am guessing that I have something configured wrong or it just can't be done. I am using Clonxilla Live 20150805-vivid-i386.
The error message is "unknown partition table format for file /temp/ocs_onthefly_local.pPerfOG/src-pt.parted!".
Is there a command line to do a disk to disk copy and ignore errors or is this not able to be doner? Could my destination drive be bad?
Could you please run these commands in the Clonezilla live command line prompt:
1. sudo -i
2. parted -s /dev/sda print
3. blkid
4. cat /proc/partitions
Please post the results of 2-4.
Steven.