Several times while Pushing up images, I would get about 90% done, then get an error message to the tune of 'File too large'. Is this referring to a file on the image I'm pushing up, or is the image itself to big?
If it's the later, how can set CZ to split the image without having to run through the whole setup again?
If it's the former, what is the maximum file size?
And while I have your attention, is there any way to have CZ pause when I get that error, instead of continuing on? That way I don't have to sit and watch my screen to make sure the image was created successfully.
Thank for your Time
Alex
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Several times while Pushing up images, I would get about 90% done, then get an error message to the tune of 'File too large'. Is this referring to a file on the image I'm pushing up, or is the image itself to big?
If it's the later, how can set CZ to split the image without having to run through the whole setup again?
If it's the former, what is the maximum file size?
And while I have your attention, is there any way to have CZ pause when I get that error, instead of continuing on? That way I don't have to sit and watch my screen to make sure the image was created successfully.
Thank for your Time
Alex
Alex,
Please do not cross post. Please post your question or problem in one forum. We will do our best to answer you.
I have replied this question in:
https://sourceforge.net/forum/message.php?msg_id=6357677
Steven.
Sorry, I posted in the other forum, then realized this one would be more appropriate.
Alex,
No problem.
Steven.