Hello everyone, I've been using Clonezilla extensively with VMware without issues but this time I'm stumped. Initially I had an issue where Clonezilla created a larger size than my VM's maximum size (i.e. 120gb became 129gb in Clonezilla) so I had to do some manual conversion of the disk to reduce the maximum disk space of my VM. Anyways these are the steps taken:
Which version of Clonezilla live did you use?
If you can, please give the testing versions of Clonezilla live, e.g., 2.7.2-12 or 20210323-hirsute a try: https://clonezilla.org/downloads.php
Steven
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello everyone, I've been using Clonezilla extensively with VMware without issues but this time I'm stumped. Initially I had an issue where Clonezilla created a larger size than my VM's maximum size (i.e. 120gb became 129gb in Clonezilla) so I had to do some manual conversion of the disk to reduce the maximum disk space of my VM. Anyways these are the steps taken:
Savedisk > Beginner mode > -z1p > -sfsck > -scs > - senc > -p
The error message I'm getting is Error: Invalid argument during seek for read on /dev/nvme0n1
Please see the attached screenshots and after I ran the following commands:
Which version of Clonezilla live did you use?
If you can, please give the testing versions of Clonezilla live, e.g., 2.7.2-12 or 20210323-hirsute a try:
https://clonezilla.org/downloads.php
Steven