Using DRBL server and images seem to install fine. My issue is that the image seems to complete in about 12 minutes which is similar to when I would image using Live direct from a USB image but after it reaching 100 percent at 12 minutes it sits there for another 10 minutes at 100 percent then finally completes successfully.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Partclone will show twice 100 percent with successfully messages, one is bitmap calculating, then is really data copy. It sometime spent much time to calculate bitmap for large disk. Please check more and report, thank you.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Using DRBL server and images seem to install fine. My issue is that the image seems to complete in about 12 minutes which is similar to when I would image using Live direct from a USB image but after it reaching 100 percent at 12 minutes it sits there for another 10 minutes at 100 percent then finally completes successfully.
So is this problem is always reproducible?
Steven.
Partclone will show twice 100 percent with successfully messages, one is bitmap calculating, then is really data copy. It sometime spent much time to calculate bitmap for large disk. Please check more and report, thank you.