Some solutions,
1. Try to use the advanced mode to change the SCSI adapter when you create a new virtual machine.
2. Try to use testing or unstable Clonezilla live.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello!
When I boot the CloneZilla live CD in a virtual machine in VMware
I get lot off scsi information
====
scsi0: *** BusLegic BT—95B Initialized Successfully ***
sd 0:0:10:7: scsi: Device offlined — net ready after error recovery
sd 0:0:10:7: rejecting I/O to offline device
sd 0:0:10:7: rejecting I/O to offline device
sd 0:0:10:7: rejecting I/O to offline device
sd 0:0:10:7: rejecting I/O to offline device
sd 0:0:10:7: [sdcb] READ CAPACITY failed
sd 0:0:10:7: [sdcb] Result: hostbyte=DID_NO_CONNECT driverbyte=DRIUER_OK,SUGGEST_OK
sd 0:0:10:7: [sdcb] Sense not available.
sd 0:0:10:7: rejecting I/O to offline device
sd 0:0:10:7: [sdcb] Write Protect is off
sd 0:0:10:7: rejecting I/O to offline device
sd 0:0:10:7: [sdcb] Asking for cache data failed
sd 0:0:10:7: [sdcb] Assuning drive cache: write through
sd 0:0:10:7: [sdcb] Attached SCSI disk
====
(up to sd 0:0:15:2 )
I have no SCSI disk, I usage IDE in VMware (virtual disks)
But the system seams to report that there is possible up to 15 scsi devices
All works fine after the bootup procedure.
But it takes time.........
I dont have this problem in a real HW or a virtual machine in VirtualBox
Is there a way to cancel/disable this scsi scanning ?
Some suggestions
TEW
Some solutions,
1. Try to use the advanced mode to change the SCSI adapter when you create a new virtual machine.
2. Try to use testing or unstable Clonezilla live.
Thanks!
1. In VirtualBox there is only IDE interface under the "advanced mode"
2.
= clonezilla live experimental =
clonezilla-live-20080511-hardy.iso == Works fine
= clonezilla live testing =
clonezilla-live-1.1.0-1.iso == Works fine
Thanks
TEW