I have a 200gb Western Digital that I'm trying to clone to a 120gb SSD.
I used gparted to resize the partition down to about 100gb. I used clonezilla to take an image of that 100gb partition as well as a 100mb system resources partition.
Now I'm going through and trying to 'restoreparts' to that 120gb drive.
Each time it takes .108 seconds and says it's complete. I've tried formatting it as NTFS in gparted, I've tried setting the partition table in clonezilla via my little knowledge of shell. Nothing is changing.
I'm not too sure where to go from here.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I hope you have got an old original clonezilla savedisk image from your 200GB Western Digital disk.
Then can you look for blkdev.list in the image and send us this one as an attachment ?
I'm following this page:
http://www.geekyprojects.com/storage/how-to-clone-hard-drive-to-smaller-drive/
I have a 200gb Western Digital that I'm trying to clone to a 120gb SSD.
I used gparted to resize the partition down to about 100gb. I used clonezilla to take an image of that 100gb partition as well as a 100mb system resources partition.
Now I'm going through and trying to 'restoreparts' to that 120gb drive.
Each time it takes .108 seconds and says it's complete. I've tried formatting it as NTFS in gparted, I've tried setting the partition table in clonezilla via my little knowledge of shell. Nothing is changing.
I'm not too sure where to go from here.
I hope you have got an old original clonezilla savedisk image from your 200GB Western Digital disk.
Then can you look for blkdev.list in the image and send us this one as an attachment ?
Is yours similarly to
'Cloning to slightly smaller target HDD' in 'clonezilla help' ?
http://sourceforge.net/p/clonezilla/discussion/Help/thread/266b4a72/