drive to drive remote

A partition and disk imaging/cloning program

Brought to you by: steven_shiau

drive to drive remote

Forum: Help

Created: 2012-09-06

Updated: 2013-04-05

Kevin - 2012-09-06

Hello,

I've pretty good w/ imaging PCs to a USB drive but would like to start using the remote disk to disk over the network.

It seems not too hard to boot and get the source/master PC up & going getting an IP from DHCP. but the part I'm stuck @ is making the target PC.

I assume you boot off clonezilla live just as I do for the master PC, but it seems specifying the target PC can't be done in the beginner mode.

Does anyone know how to specify what the target network PC is? I haven't tried it yet, but the only idea I have is using the PXE off clonezilla live.

Thanks for any ideas/suggestions

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Steven Shiau - 2012-09-09

"it seems specifying the target PC can't be done in the beginner mode." -> What did you mean?

Steven.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Kevin - 2012-09-12

You are right it has to be done from the command line, and after surfing the internet I found this page:

http://www.redshirtlinux.com/?p=463

I've tested it and it works

Thanks

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Steven Shiau - 2012-09-17

Cool!

Steven.

If you would like to refer to this comment somewhere else in this project, copy and paste the following link:

Log in to post a comment.