Data Buses go both ways on the same pin. Circuits have the ability to Input or Output but there isn't anything to allow bus-like behaviour. Possibly act as an OR gate. If either side is 1 send 1 on both if needed.
I too would really like this feature. A use case would be a tri-state register where the data could be read in from the data bus into the register, then send back out on the data bus from a sub circuit. Please consider this request
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
I too would really like this feature. A use case would be a tri-state register where the data could be read in from the data bus into the register, then send back out on the data bus from a sub circuit. Please consider this request
Please please do this.