Hello,
I've been creating some complex circuits on Logisim lately and I've ran into a weird problem that I haven't manage to fix.
On the circuit there are moments where some signals are unknown, the blue wire, the thing is that I have an "enable" that depends on one of those and when it's unknown the enable is at 1 so I makes all the rest go wrong.
Is there any way to tell Logisim with a component or setting that unknown is 0 so the enable doesn't active?
Thanks
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Hello,
I've been creating some complex circuits on Logisim lately and I've ran into a weird problem that I haven't manage to fix.
On the circuit there are moments where some signals are unknown, the blue wire, the thing is that I have an "enable" that depends on one of those and when it's unknown the enable is at 1 so I makes all the rest go wrong.
Is there any way to tell Logisim with a component or setting that unknown is 0 so the enable doesn't active?
Thanks
You can use a pull resistor to make the value 0 when the signal is unknow