Re: [BProc] 2.4.19 .config working with beoboot?

[Joshua J. E. <jj...@sa...>]

You may have had version information on modules symbols turned off when
you compiled/installed those modules and then turned it back on with a
new build.

I would wipe out the entire module directory (/lib/modules/<kernel>),
remake/install the modules and remake/install the bproc modules, then 
build a new phase2 image.  NOTE:  this might be a little extreme, but it
doesn't take that long.

-JE
-----------------------------------------------
Josh England
Sandia National Laboratory, Livermore, CA
Distributed Information Systems
email: jj...@sa...
phone: (925) 294-2076


On Fri, 2002-11-08 at 06:47, ha...@no... wrote:
> Please can someone with working beoboot-lanl.1.3 and bproc-3.2.2 and
> kernel 2.4.19 send me his/her kernel .config?
> 
> There seemes to be lot of non-obvious requirements which I am not able
> to get right...
> 
> (I get "couldn't find the kernel version the module was compiled for"
> in insmod vmadump in phase 2 while initrd seemes to contain right
> vmadump etc.)
> 
> Thanks
> 
> Vaclav
> 
> 
> -------------------------------------------------------
> This sf.net email is sponsored by: See the NEW Palm 
> Tungsten T handheld. Power & Color in a compact size!
> http://ads.sourceforge.net/cgi-bin/redirect.pl?palm0001en
> _______________________________________________
> BProc-users mailing list
> BPr...@li...
> https://lists.sourceforge.net/lists/listinfo/bproc-users