Re: [BProc] libraries not recognized on slave nodes

[Shaun K. <ske...@ya...>]

Problem:
When send beoserv the SIGHUP signal, the client comes up with an error message:
bpslave: libcache: fail list reset
I reboot the machine with beoserv reloaded, and I still get the same librt
problem.  I've installed the libs from the RPM's on the cd, and only include
those in the bplib list, but I still don't get any results.
Any ideas?
-Shaun Keenan
CSU Hayward

--- Erik Arjan Hendriks <er...@he...> wrote:
> On Wed, Aug 21, 2002 at 05:43:24PM -0700, Shaun Keenan wrote:
> > Running ClusterMatic, and I can't do much of anything because the slaves
> can't
> > find any libraries whatsoever.  I run setup_libs and it says it can't even
> run
> > tar on the slave nodes because librt.so.1 is missing.  I did a bplib -a
> > /lib/librt.so.1 and I still get the same error message.
> 
> You need to place the real file on the library list, not the symlink.
> i.e. put /lib/librt-2.2.4.so (or whatever version you have) instead of
> /lib/librt.so.1.  Then, if you don't reboot the slave in between, make
> sure you send a SIGHUP to beoserv.  That will tell it to re-read the
> list of libraries to distribute.
> 
> > I can't run beofdisk either, node_up doesn't work because there's no
> > libs...
> 
> The above problem should fix that.
> 
> - Erik


__________________________________________________
Do You Yahoo!?
HotJobs - Search Thousands of New Jobs
http://www.hotjobs.com