Its a little more complicated than AT commands. For an example take a look at the VX-8575 code (com_lgvx8575) since it is a similar phone protocol-wise. I had intended to add support for the VX-5600 myself but I haven't had the time. I might get around to it sometime in the next couple of weeks but if you want to take a crack at it go ahead.
-Nathan
On Aug 10, 2010, at 11:09 PM, Eric Schug wrote:
> Hello all,
> I have a LG VX5600 phone that I would like to get working, but I don't
> know enough about the protocol. Is there any kind of documentation or
> method to figure out how the codes work. From what I can tell it uses a
> variation of the AT commands.
> I have it currently set to vx4400 on usb ttyACM1.
> I see that bitpim tries to discover the phone but does not get anything
> until many lines later where I start to see transmit of AT+GMM..
> and the phone responds with VX5600 96....OK
> But then bitpim sends AT$QCDMG and the phone returns with ERROR.
>
>
> Eric
>
>
>
>
>
>
> ------------------------------------------------------------------------------
> This SF.net email is sponsored by
>
> Make an app they can't live without
> Enter the BlackBerry Developer Challenge
> http://p.sf.net/sfu/RIM-dev2dev
> _______________________________________________
> BitPim-devel mailing list
> Bit...@li...
> https://lists.sourceforge.net/lists/listinfo/bitpim-devel
|
