From: bwellsnc <bwe...@gm...> - 2010-06-09 19:10:28
|
OS: CentOS 5.5 Bacula Version: 5.0.2 Hello. I am able to write data to my quantum superloader 3 only by basically moving the tape manually and disabling the autochanger. Here is the situation. This unit has an 8 tape magazine. I have a tape in SLOT 1. When I attempt to run a backup job to tape, I receive the below error: 3302 Autochanger "loaded? drive 0", result: nothing loaded. 09-Jun 14:38 servername-sd JobId 496: 3301 Issuing autochanger "loaded? drive 0" command. *messages 09-Jun 14:38 servername-sd JobId 496: 3302 Autochanger "loaded? drive 0", result: nothing loaded. It repeats several times, then states I have to load a tape manually that matches the label it’s looking for. The tape is labeled and has been written to. I know this because I disabled the autochanger function and made it a straight tape drive for testing. I have gone through everything concerning this unit in the mailing list. Everyone says it works, but I am unable to get it to work with the autochanger. Also, I noticed that when it starts a backup if I have a tape in the drive, it takes the tape out and cannot find the tape. I then get the error above. I want to backup to the tape until it is full. This is for a one time backup I perform weekly. I just want to append to the tape until I need to send the tape offsite at the beginning of the month. Then I will start with a fresh tape. If anyone can help, I would appreciate it. Thanks! Brent |